 Search the Knowledgebase |
 Browse by Category |
|
|
|
| The File | Template | Save command is grayed out? |
| User Opinions |
|
No users have voted.
|
|
Thank you for rating this answer.
|
In Strater 1, you have to be in Design Mode to save a borehole design as a template.
There are a couple ways to switch to Design Mode. You could do any of the following:
- Go to Tools | Design Mode
- Press the F4 key
- Click the Design Mode button on the Borehole Design toolbar
To make sure you are in Design Mode, go to View | Borehole View Properties and check the View Mode in the Property Inspector.
Refer to the Golden Software Newsletter Article about Strater Templates for additional information. http://www.goldensoftware.com/newsletter/Issue51st.shtml
In Strater 2, you do not have to be in Design Mode to save a template. Simply go to File | Save As and save your borehole view as template file.
|
| Visitor Comments |
|
No visitor comments posted. Post a comment
|
| Attachments |
|
No attachments were found.
|
Print this page
Email this page
Post a comment