logo

img

 
powered by

img

Buy Now

Knowledgebase Home | Contact Knowledgebase Home | Contact
Search the Knowledgebase Browse by Category

[Advanced Search]
My log goes from 0 to 100 feet. How can I have it show 1?=10? so that the log is 10? long?
Would you like to...
Print this page
Email this page
Post a comment
User Opinions
No users have voted.
How would you rate this answer?
Helpful
Not helpful
You can set the scale of the map in the view properties (borehole view properties in Strater 2). You can access the view properties by deselecting everything (Ctrl+Shift+A), clicking in the white space outside the page margin, or by clicking View | View Properties (View | Borehole View Properties in Strater 2).

In the Property Manager, the method depends on what is set for the Depth Settings. If the Depth Settings is set to:
  • Automatic, then set the Auto-recalculate Scale to False, and then set the Scaling Depth Per Inch to 10.
  • Collars Table, then in the actual collars data table you can enter 10 into the Scale column for that Hole ID. Or, you can set the Auto-recalculate Scale to False, and then set the Scaling Depth Per Inch to 10.
  • User Defined, then simply set the Scaling Depth Per Inch to 10.
See also:
How can I show certain depth ranges per page in my borehole design?
How do I set the scale so that it is 1:500?
How can I set a permanent scale, but have the starting/ending borehole depths change according to the data?
My logs are all over 200m long. How do I set the scale so that only 20 m is shown on each page?
Visitor Comments
No visitor comments posted. Post a comment
Related Questions
Attachments
No attachments were found.
Products